Toilet bowl installation may appear overwhelming, but working with a good plan, and showing a bit of patience can make this a simple DIY task. To make a leak-free flush possible, meticulous attention to installation detail is required. When replacing an old toilet or even installing a new toilet, properly secured installations greatly improves your bathroom’s efficiency. If toilets are correctly installed, there will be no damages caused due to water, and no plumbing expenses that are highly avoided.
Why Implementing a Leak-Free Toilet Installation is Important?
Leaking toilets, besides being inconvenient, can also cause expensive repairs to water damage. Unsealed toilets allow a large volume of water to escape to your bathroom floor. Correct seal installation prevents leaking toilets from constantly needing maintenance. For expert guidance and professional services to ensure your installation goes flawlessly, go to https://www.plumbersingapore.org/toilet-bowl-installation/ .
Gathering Tools and Materials
Ensure that your tools and materials are gathered beforehand to save time during the installation process. You’ll need the following:
- Plant Wrench Screws
- Screwdriver
- Plumber’s Putty
- Level
- Tape Measure
- Bucket and Towels
- New toilet bowl
- Wax Ring
- Toilet Flange
If you need any assistance or advice on the best materials or tools, visit https://www.plumbersingapore.org/ for expert recommendations.
Dismounting the Old Toilet
Remove the current toilet bowl prior to installing a new one. First of all, switch off the water supply and flush the toilet to drain the tank. After that use a wrench to unscrew the water line from the tank, and unbolt the toilet from the floor. Carefully lift the toilet from the flange after unscrewing the bolts and place it aside for now.
Position the New Wax Ring
Now prepare the flange for your new toilet. New toilet fits by using a proper installation wax ring like this:
- Cleaning The Flange: Pick off the old wax ring left over from the flange. Clean the wax ring residue and surrounding area to ensure a tighter seal.
- Put The Wax Ring In Place: Grab the new wax ring and press it onto the base of the toilet until it fits into sink and covers the flange completely.
- Check the Rings Position: The wax ring must be perfect where it’s meant to be so that it can align with the flange competitively without leaks.
Set and Position the Toilet Bowl
Once the wax ring is ready, carefully set your new rest room in place. Gently set the toilet bowl down onto the flange so that the bolts coincide with the holes in the base of the rest room. For a tight seal to be created with the wax ring, the toilet has to be pressed downwards firmly.
Connect the Water Supply and Flush Test
Once the toilet bowl is secured into place, connect the water supply line back to the tank. Let the water commence once more, allowing the tank to fill. Once filled, flush the toilet to determine if there’s any seeping water near the base as well as the water supply connection.
Finish Up and Install the Toilet Seat
To conclude, follow the installation guidelines in the manual for placing the toilet lid. Once installed, step away and enjoy your work. The toilet bowl is installed, and can now be used.
What are the common Mistakes to Avoid during Installation?
In order to achieve a properly leak free flush, common mistakes people make with installation should be avoided.
- Leaving out leak testing: After installation of the toilet, the next step is to conduct testing to pinpoint any potential leaks.
- Improper seal: A wax ring that is incorrectly positioned will leak water at the base and not hold water.
- Excessive tightening of bolts: In an attempt to protect the toilet bowl, do not tighten the bolts too much otherwise you will crack the bowl.